The VSME becomes the Voluntary Standard. What changes for SMEs?

A new name, a target group of up to 1,000 employees, fewer datapoints and a limit on what customers may ask: this is what changes with the VS.

November 20, 2026

5 minutes

Lisa Roels

Two people discussing a report with charts at a table

Since 24 September 2026, the VSME has been laid down in a European regulation and is now called the Voluntary Standard (VS). The voluntary sustainability standard for SMEs gets a new target group, fewer datapoints and a legal limit on what customers may ask. What does this mean in practice for your company?

In short

  • Delegated Regulation (EU) 2026/1560 lays down the VSME and replaces the recommendation of July 2025. Reporting under the VS remains voluntary.
  • New name: the VSME is now officially called the Voluntary Standard, or VS for short.
  • Target group: any company with up to 1,000 employees on average. Turnover and balance sheet total no longer play a role.
  • Value chain cap: from financial year 2027, CSRD companies may not ask suppliers with up to 1,000 employees for more than what the regulation provides for.
  • Small companies: companies with 10 employees or fewer report less. Energy, water and waste become voluntary for them.
  • Content: a number of datapoints disappear, a few become stricter.

What happened

Earlier this year, the Omnibus I Directive (2026/470) established that companies with fewer than 1,000 employees do not have to give their customers information that goes beyond the voluntary VSME standard. With the new regulation, it is now also fixed what that standard contains.

Delegated Regulation (EU) 2026/1560 dates from 24 September 2026 and replaces the European Commission recommendation of July 2025. EFRAG published the accompanying guidance in September 2026.

The regulation in detail

A new name and target group: the Voluntary Standard

The VSME is now officially called the Voluntary Standard (VS). The old name referred to SMEs with up to 250 employees, while the VS is open to companies with up to 1,000 employees. The structure with a basic module and a comprehensive module stays. If a questionnaire still mentions the VSME, it is the same standard.

From when does the VS apply?

You can already use the VS now, but the standard is intended for financial years starting on or after 1 January 2027. For most companies, the report on 2027 is therefore the first one fully under the VS. The value chain cap also applies from then.

Are you still working on a report on 2025 or 2026 under the VSME? You do not have to redo it, as long as you state which version you use. If you still have to start, it is best to switch to the VS straight away, so your report on 2026 already lines up with the one on 2027.

Value chain cap: a limit on what customers may ask

From financial year 2027, companies that fall under the CSRD may not ask suppliers with up to 1,000 employees for more than what is in Annex II of the regulation. What falls within that limit depends on your size:

  • Every supplier: a basic set about the company and its workforce, such as accidents and pay.
  • Suppliers with more than 10 employees: on top of that, among other things, energy consumption and CO₂ emissions.
The cap only applies to requests under the CSRD. Banks or other legislation can still ask for more information.

Small companies report less

If you have 10 employees or fewer, the datapoints on energy, water and waste become voluntary. A number of topics about your workforce do remain mandatory. So if you only supply energy figures, you cannot give a valid statement of compliance.

Fewer datapoints, stricter on two points

  • Removed: among others, GHG intensity and the surface area of your sites. A number of workforce questions also disappear.
  • Stricter on two points: first, you now explicitly state that your report complies with the VS. The second point concerns reporting employee turnover for those who also use the comprehensive module.

Consequences for companies

What does this mean for suppliers?

The cap protects you against questionnaires that keep getting longer. Part of what customers ask for today falls outside it. Still, the cap only applies from financial year 2027 and only to CSRD requests. Customers will keep asking for data, and if you supply it quickly and correctly, you stand stronger.

What does this mean for companies that already report under the VSME?

You cannot simply carry over a report based on the 2025 recommendation. Some datapoints have been removed, others are defined differently. As a result, figures can shift without anything having changed in your company. Four topics need extra attention:

  • Accidents: an accident now only counts from a certain level of severity. Your figure will therefore probably drop. If you compare with last year, that needs some explanation.
  • Human rights: according to the guidance, an incident only counts if it has been formally established. What you reported last year is therefore not automatically still correct.
  • Biodiversity: more types of protected areas now count, including Ramsar sites, and what you report per site has changed. An earlier screening of your sites may therefore no longer be enough.
  • Waste: you report what share of your waste goes to recycling or reuse. How you count that has been clarified, and the result is not always the figure you get from your waste processor.

Use the 2026 EFRAG guidance for this, available on the EFRAG Knowledge Hub. The 2025 version still describes datapoints that have since been removed.

Timeline

July 2025
the European Commission publishes the VSME as a recommendation.
September 2026
EFRAG publishes the new guidance and the VSME is laid down as the Voluntary Standard in Delegated Regulation (EU) 2026/1560.
Financial year 2027
the VS applies to financial years starting on or after 1 January 2027 and the value chain cap applies to requests from CSRD companies to suppliers with up to 1,000 employees.

What we tell our clients

The VS remains voluntary. Still, for many SMEs this is the most important sustainability news of the year.

For the first time, the law sets out what a large customer may ask of you. That is a gain. But the cap is no reason to do less. Customers will keep asking for data, and the figures within the cap are the figures you need yourself to steer your business.

Our recommendation: put your previous report or your completed questionnaires next to the new regulation before you start your next report. That way you see straight away which figures you need to calculate differently, what you can drop and which customer questions fall outside the cap.

What is your next step?

Not sure what the new standard means for your company, or have you received a questionnaire from a customer that goes beyond the cap? Feel free to get in touch with Mantis.

Sources: Delegated Regulation (EU) 2026/1560 and the EFRAG guidance of 22/09/2026.

Is your customer asking for more than the new standard allows?

We put your previous report or questionnaire next to the VS and tell you what you need to change.

About the author